Related YOUTUBE Channel
SME-unit1-Wind Power Plant Explaination
SME- unit-1 Introduction to Power Plants
SME-unit1- Hydro Power Plant Explaination
SME-unit1-Steam Power Plant Explaination
SME-unit1-Solar Power Plant Explaination
SME-unit1-Nuclear Power Plant Explaination
3. The alternator is used in power plants which converts.....?
Explanation:
4. Name the Power Plant....?
Explanation:
5. Minimum quantity of fuel is required in.....?
Explanation:
6. In regenerative cycle feed water is heated by........
Explanation:
7. Heat is mainly transferred by conduction, convection and radiation in..?
Explanation:
8. Standby loss is maximum in......?
Explanation:
9. Name the Energy Conversion Device....?
Explanation:
10. Which of the following station is least efficient......?
Explanation:
11. Francis,kaplan and propeller turbines fall under the category of.......
Explanation:
12. The multi stage compression as compared to single stage compression......
Explanation:
13. Pelton turbine is suitable for high head and....?
Explanation:
14. ldentify the Power Plant showen below ?
Explanation:
15. Pelton wheel turbine is used for minimum of the following heads.....
Explanation:
16. Compression efficiency is compared against.......
Explanation:
17. Identify the Energy Conversion Device....?
Explanation:
18. The Da-Lavel impulse turbine is a...?
Explanation:
18. The capacity of an overhead tank is 2400 m³. This required to be filled by a pump which required to pump water upto a height of 18 m in 40 minutes.Find the power required by the pump?
Explanation:
Volume of tank, V=2400 m3, Time, t=40 min , H=18m
Rate of discharge from pump.
Q = V/t= 2400 (m3) / (40x 60(s))
= 1m3/s
Power, = p x g x Q x H x 10 -3 kW
= 1000 x 9.81 x 1 x 18 x 10 -3 kW
= 176.58 kW
Hence, the power required by the pump is 176.58 kW.
Post a Comment
0 Comments